Infrared lamp for glass breaking

Fri, 05 Jun 2026 05:01:33 +0800

On the tempering line, a slow, uneven heat profile in the breaking zone isn’t just a bottleneck—it’s scrap you can see in real time. When the thermal field gets squirrelly, the glass fractures inconsistently. You end up with bends that miss the target, stress that’s all over the map, and a pile of wasted material. What matters technically We built the infrared lamp module specifically for the breaking station. Short-wave quartz emitters give you fast response and tight control. Ramp-up hits setpoint in 3–5 seconds, with a stable working temperature range up to 1,200°C. Power density is tuned to 35–55 W/cm² across the hot zone—enough to beat convection losses and match the thermal mass of typical automotive and architectural glass thicknesses. Temperature uniformity stays within ±3% across the active length, which cuts the thermal gradients that drive unwanted stress. The emitters run on 230/400 V, with standardized terminals and mounting centers for straightforward integration. Here’s why it plays well on the line: fast, repeatable heating keeps the process honest. The lamp comes back to temperature quickly after each cycle, so the breaking step stays in step with the furnace and bending section. Uniformity is consistent enough that the break follows the intended path, with fewer micro-cracks and less edge tearing. That means fewer rejects, less rework, and a yield you can plan around. Energy stays disciplined, too—the module heats on demand instead of idling, and the focused infrared energy couples cleanly into the glass surface. Installation is straightforward, but alignment is non-negotiable. Even a small mis-angle shifts the irradiance profile and can move the break line. Keep the quartz clean—oil, dust, or coating residue scatters energy and drops output. Treat reflector inspection and emitter replacement as routine maintenance. Running near the upper temperature limit shortens service life, so setpoints should match the glass type, not the hardware limit.

Breaking on Rapid Infrared Heating Solutions

Infrared lamp for glass breaking