Solar glass coating dryer

Sun, 05 Jul 2026 14:42:30 +0800

Introduction

We built this infrared heating lamp for one specific job: drying solar glass coatings right after the ink is printed. You know that maddening bottleneck where the glass is too wet to stack? This solves it. It gets the surface dry in seconds, so the glass can move to the next step immediately. No more worrying about sheets sticking together. Just smooth, immediate turnover.

The Tech, Without the Fluff

Here’s the core of it: we used a shortwave infrared halogen design. It’s all about delivering the kind of power density that makes fast surface curing possible. It runs on a 400V supply and pulls 2500W through a compact 300mm tube. That tight power-to-length ratio is intentional. It concentrates the heat into a small footprint—just wide enough to match the printing exit lane. So you get a focused blast of heat hitting the wet coating the second the glass leaves the press. Not spread out. Just right where you need it.

Solar on Rapid Infrared Heating Solutions

Solar glass coating dryer

Introduction

The Tech, Without the Fluff