How to Build an IR Cure Cycle From a Paint Technical Data Sheet
Complete how to build an ir cure cycle from a paint technical data sheet through a controlled sequence with recorded hold points. Keep coating chemistry, panel temperature and booth safety in the same decision. A faster temperature rise helps only within the film and substrate limits.
Preconditions
Confirm the part, material, equipment revision, applicable instructions, safety controls, calibrated sensors and acceptance criteria. Stop if a required input is missing.
Procedure
- Record the starting condition and the predicted hot and cold locations.
- Set a bounded initial configuration from governing data and equipment limits.
- Run the process while recording the complete temperature and control history.
- Hold at each planned review point and compare the result with the stop conditions.
- Cool, inspect and release only against the predetermined criteria.
Hold points that prevent guesswork
- Follow the coating technical data for flash-off, temperature, exposure and handling limits.
- Measure representative panel locations; the lamp setting is not the panel temperature.
- Include distance, angle, curvature, colour, substrate and nearby heat sinks.
- Keep booth ventilation, worker controls and the safe operating sequence active.
- Use the coating system’s specified finish or handling checks for release.
Record the hardware role
Oyate documents lamp-level voltage, power, dimensions and wavelength for industrial IR lamps; paint drying is listed as a candidate application. Consult the configured oyate product record once the mechanical, electrical, optical and process requirements are known. A catalogue cannot replace qualification.
Completion standard
Completion requires an intact record, compliance with every limit, and an authorized disposition for each deviation.
Related articles
- Why Flash-Off Must Come Before Infrared Paint Curing
- Lamp Setting vs Panel Temperature in Automotive IR Curing