Lamp Setting vs Panel Temperature in Automotive IR Curing
Define the measurand, test conditions and acceptance criteria for lamp setting vs panel temperature in automotive ir curing before collecting data. Keep coating chemistry, panel temperature and booth safety in the same decision. A faster temperature rise helps only within the film and substrate limits.
Define what pass means
State the exact part, material, equipment revision, operating condition and decision that the study will support. Approval criteria must exist before the first result is viewed.
Build the evidence plan
| Gate | Question | Minimum record |
|---|---|---|
| Scope | What exact condition is being qualified? | Part, material, equipment and revision |
| Measurement | Where are the likely hot and cold points? | Sensor map and calibration status |
| Repeatability | Does the result persist under representative loading? | Comparable repeated runs |
| Acceptance | Which limits decide pass or fail? | Pre-approved criteria and disposition |
Locate and control the measurements
- Follow the coating technical data for flash-off, temperature, exposure and handling limits.
- Measure representative panel locations; the lamp setting is not the panel temperature.
- Include distance, angle, curvature, colour, substrate and nearby heat sinks.
- Keep booth ventilation, worker controls and the safe operating sequence active.
- Use the coating system’s specified finish or handling checks for release.
Run and repeat the test
Record the complete heating and cooling response, then repeat representative runs until a stable result can be distinguished from measurement scatter.
Bound the product claim
Oyate documents lamp-level voltage, power, dimensions and wavelength for industrial IR lamps; paint drying is listed as a candidate application. Consult the configured oyate product record once the mechanical, electrical, optical and process requirements are known. A catalogue cannot replace qualification.
Retain the release record
Keep raw data, calibration status, setup photographs, deviations, acceptance calculations and the authorized disposition.
Related articles
- Thermocouple or Infrared Thermometer for Paint-Cure Verification?
- How Lamp Distance, Angle and Exposure Time Shape a Paint-Cure Cycle